SH26 Onetai Bridge Replacement Physical Works

Details

This is a Physical Works contract for the demolition and replacement of SH26 Onetai Stream Bridge (BSN841). Onetai Stream Bridge is a 9m long bridge located approximately 14km north of Paeroa and carries SH26 over Onetai Stream.

The Contract Works comprise of:
• Replacement of the existing Onetai Stream Bridge with a bridge comprising a timber superstructure;
• Construction of new reinforced concrete abutment;
• Construction of new mechanically stabilised embankments with mass block retaining walls;
• Construction of instream scour protection measures including reno mattress, rip rap and insitu concreting;
• Civil works including safety barriers, pavements, carriage widening, roadside furniture, signage and line marking;
• Temporary traffic management;
• Service relocations and protection
• Temporary Works design including but not limited to temporary propping, craneage and confirming adjacent ground conditions for crane foundations and improvements if needed.
• Riparian planting.

The Contract period is 60 Working Days and the Due Date for Completion of the Contract Works is no later than 31 March 2025. It is envisaged that the Contractor will utilise a single full road closure to undertake the majority of the site-based Contract works. This road closure has been included as a Separable Portion, with flexibility given to Contractors regarding the timing and duration of the Separable Portion which sits within the Contract period.

The new timber superstructure is viewed by NZTA as a prototype solution for sustainable replacement of short-span vehicle bridges. The glue-laminated timber and plywood deck and kerb materials for the new superstructure are being supplied by NZTA.

Only tenderers pre-qualified to “Bridge Construction – Level A (3A)” under the terms of the Transport Agency’s Prequalification System are eligible to submit a tender.

Electronic copies of the Request for Tender documentation are attached to this advertisement.

All tender queries are to be submitted via the GETS Q & A Portal.

All responses to tender queries/clarifications will be answered by Notice to Tenderer which will be available in the GETS addenda.

Tender submissions shall be uploaded to GETS eTender box in two separate files. The GETS file upload limit is 50MB. The files should be labelled:
• File No 1 –8646 – Proposal excluding Price
• File No 2 – 8646 – Price

Tender submissions will only be accepted electronically via the GETS eTender Box.